Maytag MGT3800XW Installationsanleitung PDF herunterladen (Seite 16)

CONNECT INLET HOSES

Washer must be connected to water faucets with new inlet

hoses with at washers (not provided). Do not use old hoses.

NOTE: Both hoses must be attached and have water owing

to inlet valves. If you are only connecting to a cold water

faucet, you must use a Y-adapter (not included).

Attach hose to hot water faucet. Screw on coupling by hand

until it is seated on washer. Use pliers to tighten couplings an

additional two-thirds turn. Repeat this step with second hose

for cold water faucet.

IMPORTANT: Do not overtighten or use tape or sealants on

valve when attaching to faucets or washer. Damage can result.

HELPFUL TIP: Make note of which hose is connected to hot

water to help in attaching hoses to washer correctly. In most

standard congurations, hoses will cross over each other

when attached correctly.

2. Connect inlet hoses to water faucets

Insert a new at washer into each end of the inlet hoses

(not provided). Firmly seat the washers in the couplings.

1. Insert washer into each hose

Washer Coupling

Run water for a few seconds through hoses into a laundry tub,

drainpipe, or bucket to prevent clogs. Water should run until clear.

Attach hot water hose to the bottom inlet valve. Screw

coupling by hand until it is snug. Use pliers to tighten

couplings an additional two-thirds turn. Repeat with cold

water inlet valve (top valve).

IMPORTANT: To reduce risk of hose failure, replace the hoses

every 5 years. Record hose installation or replacement dates

for future reference.

Periodically inspect and replace hoses if bulges, kinks, cuts,

wear, or leaks are found.

4. Connect inlet hoses to washer

3. Clear water lines

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Keine Kommentare

Maytag MGT3800XW Installationsanleitung Seite 16