Maytag MC2 Bedienungsanleitung

MAYTAGCommercial Dryer - 30 lb. PC2, MC2 & MN2, 50, 75 and 100 lb.Installation/Operator’s ManualWARNING: For your safety the information in this m

The tumblers of the 30, 50, and 75 lb. model dryers are supported during shipping by a wooden block. Remove the block before starting the dryer.The li

C. DRYER ENCLOSURE REQUIREMENTSBulkheads and partitions should be made of noncombustible materials and must be located a minimum of 12 inches above t

E. EXHAUST REQUIREMENTSExhaust duct work should be designed and installed by a qualified technician. Improperly sized duct work will create excessive

F. ELECTRICAL INFORMATION1. Electrical RequirementsIt is your responsibility to have ALL electrical connections made by a properly lice

For added personal safety, when possible, it is suggested that a separate ground wire (no. 18 minimum) be connected from the groun

5. 3-Phase Wiring ConnectionsThe only electrical input connections to the dryer are the 3-phase power leads (LI, L2, L3, N) and grou

The dryer must be connected to the type of heat/gas indicated on the dryer data label located on the inside of the control door. If

Consistent gas pressure is essential at ALL gas connections. It is recommended that a 3/4" pipe gas loop be installed in the s

H. PREPARATION FOR OPERATIONThe following items should be checked before attempting to operate the dryer:1. Read and follow ALL "CAUTION,"

During this purging period, check to be sure ALL gas shut-off valves are open. If the dryer still fails to heat, refer to the troubl

Retain This Manual In A Safe Place For Future ReferenceThis product embodies advanced concepts in engineering, design, and safety. If this

SECTION IV100 lb. INSTALL ATION INFORMATIONA. LOCATION OF THE DRYERIf more headroom is needed when moving the dryer into position, the to

NEAREST COMBUSTIBLETO OPEN.»12- OR MORE CLEARANCE IS SUGGESTED, ESPECIALLY IN CASES WHERE SPRINKLER HEADS ARE OVER THE DRYERSMAN3724INSTALLATIO

B. FRESH AIR SUPPLYWhen the dryer is operating, it draws in room air, heats it, passed this air through the tumbler and exhausts i

C. EXHAUST REQUIREMENTSExhaust duct work should be designed and installed by a competent technician. Improperly sized duct work will create excessive

If it is not feasible to provide separate exhaust ducts for each dryer, ducts from the individual dryers may be channeled into a common main duct. Eac

SECTION VOPERATING INSTRUCTIONS30. 50. 75 & 100 lb. ModelsA. MECHANICAL COIN METER CONTROLS (non-computer)1. The controls of a coin-metered model

1. The controls of a timer model dryer consist of;B. MECHANICAL TIMER CONTROLS (non-computer)ComponentDrying TimeCool-DownTimer Heat Selector Switch

C. PPL COMPUTER MODELS (non-computer)NOTE: The programs have been pre-set at the factory, for changes in the program consult the User's Manual or

Manually Operated Automatic Mode1. When turning on power, or when no cycle is in progress, the L.E.D. display will read "FILL".2. Press ke

SECTION VIMAINTENANCEA. CLEANINGA program and/or schedule should be established for periodic inspection, cleaning, and removal of lint f

IMPORTANTYOU MUST DISCONNECT and LOCKOUT THE ELECTRIC SUPPLY and THE GAS SUPPLY or THE STEAM SUPPLY BEFORE ANY COVERS or GUARDS ARE REMOVED

90 DaysOn 100 lb. models, remove lint from the motor air vents and surrounding area.IMPORTANT:Lint accumulation will restrict internal motor air flow,

SECTION VIIPROCEDURE FOR FUNCTIONAL CHECK OF REPLACEMENT COMPONENTS1. Microprocessor (computer) Boarda. Upon completing installation of the replacem

g. The microprocessor (computer) board's L.E.D. display must read "DOOR."h. Close the main door and restart the dryer.i. Functional

PartNo. 113033 1-01/30/98-100 2-06/19/98-100 3-07/31/98-2504-12/23/98-250MAYIÄG

FOR YOUR SAFETYDO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.DO

Table of ContentsSECTION IIMPORTANT INFORMATION...

SECTION IIMPORTANT INFORMATIONA. RECEIVING and HANDLINGThe dryer is shipped in either a protective polyethylene cover and protective comers or is enc

WARNING: Dry only water-washed fabrics. DOiVOJdryarticlesspottedorwashedindry cleaning solvents, a combustible detergent, or "ALL PURPOSE" c

SECTION IISPECIFICATIONS30 LB 50 LB 75 LBMaximum Capacity (Dry I\feight)301b. 13.6 kg 501b.22.7 kg751b. 34 kgTumblff Diameter 30" 76.2 c 32-3/4&q

SECTION IIIINSTALLATION PROCEDURESInstallation should be performed by competent technicians in accordance with local and state codes. In the abse