Maytag MEDX655DW Installationshandbuch

1W10562358AW10562359A-SPDRYER SAFETY ... 2INSTALLATION REQUIREMENTS ...

104-wire Direct Wire Connection IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do not permit 3-wire connections. Un

113-wire Direct Wire ConnectionUse where local codes permit connecting cabinet-ground conductor to neutral wire. B5. Remove center screwRemove center

121. Prepare to connect neutral ground wire and neutral wireAEBRemove center terminal block screw (B). Remove neutral ground wire (E) from extern

13Venting RequirementsVENTINGExhaust hoods: Must be at least 12" (305 mm) from ground or any object that may obstruct exhaust (such as owers,

14Plan Vent SystemRecommended exhaust installationsTypical installations vent the dryer from the rear of the dryer. Other installations are possible.B

15Vent System ChartNumber of 90° turns or elbowsType of ventBox/louvered hoodsAngled hoods14320Rigid metalRigid metalRigid metalRigid metalRigid me

16Connect VentConnect vent to exhaust outlet1.Using a 4" (102 mm) clamp, connect vent to exhaust outlet in dryer. If connecting to existing vent

17Reverse Door Swing (Optional)29" Super Wide Side-Swing DoorPlace towel on top of dryer to avoid damaging the surface.NOTE: Magnetized screw dri

18Remove the door catch, bezel, and plug from the inside of the inner door by squeezing and pulling/pushing them. Place the door catch, bezel, and plu

19TroubleshootingSee the Use and Care Guide or visit our website and reference Frequently Asked Questions to possibly avoid the cost of a service call

2DRYER SAFETY

05/13 Printed in U.S.A. W10562358A W10562359A-SP®/™ ©2013.All rights reserved.

3

4 Level Caulking gun and compound (for installing new exhaust vent)Parts package is located in dryer drum. Check that all parts are included.Parts ne

5A. Wide opening side-swing doorB. Wide opening hamper door*Most installations require a minimum 5½" (140 mm) clearance behind the dryer for t

6If your outlet looks like this:If your outlet looks like this:If connecting by direct wire:Power supply cable must match power supply (4-wire or 3-wi

7Electrical ConnectionPower Supply CordElectrical Connection Options1. Choose electrical connection typePower supply cord 4-wire receptacle(NEMA Type

8Direct WireABCDEF2. Remove terminal block coverBefore you start, disconnect power. Remove hold-down screw (D) and terminal block cover (A).A. Termin

93-wire Power Supply Cord ConnectionUse where local codes permit connecting cabinet-ground conductor to neutral wire. ABDCEFGA. 3-wire receptacle (NE