Maytag PD Anleitung zur Fehlerbehebung PDF herunterladen (Seite 5)

PR & PR/PD READER SETUP PROCEDURE

Smart Vend PR & PR/PD Readers

The PR & PR/PD Readers can be setup with the same setup card sets. Only a retro-fit reader will

need a special set of setup cards to be setup. The key to successfully setting up a PR or PR/PD

Reader is to insert each card #1 - #4 in sequential order waiting for each card for the “Pull Card”

message on the Maytag Board Display. If a reader displays an error code when attempting to set it

up then revert back to the #1 Key Card and try again from the beginning. Sometimes the reader can

already have keys installed into the device and by inserting the Key Card the reader may have lost its

system keys.

Both the PR and PR/PD readers are setup exactly the same and operate identical.

1. Connect the Smart Vend PR or PR/PD reader to a Maytag Circuit Board.

2. Plug in the machine.

3. Attempt to test the reader with a user card to see if the reader is pre-programmed. If the

user card is accepted your reader is ready for operation. If the user card is not accepted

then proceed to the next step in programming the reader.

4. Insert the Key Card. “Card # 1” and wait until the display indicates to remove the card.

5. Insert the Site Code Card “Card #2” and wait until the display indicates to remove the

card.

6. Insert the Price Card “Card #3” ” and wait until the display indicates to remove the card.

7. Insert the Service Mode Card “Card #4” ” and wait until the display indicates to remove

the card.

8. Insert the User Card “Card #5” and verify the reader is reading the value card indicating

the card value on the display.

9. Turn off the power and the reader is complete. If the reader cannot read the value repeat

steps 1through 8 and try again. If the reader still does not read cards please contact Smart

Vend.

1 2 3 4 5 6 7 8 9 10 11

Keine Kommentare

Maytag PD Anleitung zur Fehlerbehebung Seite 5