Maytag AOCS3040 Bedienungsanleitung PDF herunterladen (Seite 6)

Jenn-Air, Maytag and Magic Chef Fault Codes

WARNING

To avoid risk of electrical shock, personal injury or death; disconnect power and gas supply to oven before

servicing, unless testing requires power and/or gas.

PRODUCT(S): FREESTANDING RANGES EMPLOYING RS1, T1 & T2 CLOCKS

MODEL YEAR(S): APRIL 1997 TO PRESENT

NOTE: Excluding Gemini, Accellis 2X

Fault

Code

Problem Component(s) to Check

F1 Indicates error in the control circuitry ........................... Ohm sensor and harness resistance (see Table 2

below), check door lock mechanism, harness,

switch connections, inspect membrane.

F3 Sensor/sensor circuitry................................................. Test for proper resistance value. Also check for

frayed/pinched wiring, or connector damage.

Replace as necessary. At room temperature, the

probe’s resistance should be 1050 -1100 ohms.

DO NOT REPLACE CONTROL.

F9 Door lock circuitry fault sensed .................................... Check the door lock switch wiring and lock

assembly, adjust or replace as needed. DO NOT

REPLACE CONTROL. This fault code appears

if control is unable to recognize the opening and

closing of the door lock switches at the proper

times. Control is looking for a signal back from

the door lock system circuitry to ensure door is in

the proper position for the function chosen.

F1-1 Oven temperature above 650˚ F when bake/broiling... Check door lock, oven sensor, and harness.

If ok, replace control.

F1-2 Oven temperature above 905˚ F during cleaning ........ Check door lock, oven sensor, and harness.

If ok, replace control.

F1-3 Shorted sensor ............................................................. Ohm sensor and harness.

F1-4 Keyboard disconnected................................................ Inspect ribbon and ensure it is making a good

connection. If ok, replace control.

F1-5 Cancel key out of specification..................................... Replace control.

F1-6 Relay activated............................................................. Replace control.

F1-7 Microprocessor not sensed .......................................... Replace control.

F1-8 Option or sensor input failure ....................................... Inspect ribbon and ensure it is making a good

connection. Ohm sensor & harness and ensure

proper sensor connection. If ok, replace control.

F1-9 EEPROM error ............................................................. Replace control.

F3-1 Sensor/sensor circuit failure......................................... Ohm sensor and harness.

F9-1 Door will not lock .......................................................... Check wire connections.

If ok, replace motorized door lock.

F9-2 Door will not unlock ...................................................... Check wire connections.

If ok, replace motorized door lock.

F9-3 Door lock is locked and unlocked at the same time..... Check wire connections.

If ok, replace motorized door lock.

Table 2: Sensor Resistance, Freestanding Ranges, 1997 to Present

Degrees F (C) Sensor Resistance

100 (37.7) 1143

200 (93.3) 1350

300 (148.8) 1553

350 (176.6) 1654

400 (204.4) 1753

500 (260) 1949

1 2 3 4 5 6 7 8 9 10 11 ... 18 19

Kommentare zu diesen Handbüchern

Keine Kommentare

Maytag AOCS3040 Bedienungsanleitung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Öfen Maytag AOCS3040